Drive Operation; Starting The Rc-System; Starting The Engine - Carson DAZZLER RTR Manual De Instrucciones

2WD Buggy DAZZLER

Drive operation

Starting the RC system
- Pull the transmitter antenna out completely.
The range of the radio signal is reduced if the antenna is
not pulled out completely.
CAUTION!
Always turn the transmitter´s power switch ON first!
Thread the antenna cord through the antenna pipe and
put the antenna pipe into the antenna foot on the chassis
Switch on the receiver at the On/Off switch on the chassis
- Make sure that the carburettor outlet is in idle position when the
receiver is switched on.

Starting the engine

The on-board starter spins the crankshaft of the nitro engine
in order to ingest the fuel through the carburettor into the
combustion chamber.
- Press the start button
Press the button once, then the preheating of the glow plug
starts for 20sec. (Orange LED is lit)
- Press the button one more time, engine starts.
(Red LED is lit)
Do not hold the button down for more than 5 seconds at a time.
Engine does not start
If engine does not start, please check whether the fuel has
reached the inlet of the carburettor.
Carburettor inlet
If fuel has not reached the carburettor inlet,
- hold a rag over the end of the muffler exhaust pipe as per
attached picture and
- press the engine start button on transmitter several
times for 1-2 seconds until fuel reaches the carburettor.
No. 103003
09/06
All manuals and user guides at all-guides.com
On/Off switch
Antenna foot
On/Off switch
Start button
31