JBL SYNTHESIS SDR-38 Manual página 40

Problem Check the following
Where the interference is coming from. Switch off each source
There is radio or television reception
component in turn, then any other equipment. Most electronic
interference
equipment does generate low levels of interference.
Try re-arranging cabling from the nuisance source away from other
cabling.
Ensure that the cabling used is high quality, specified for its purpose,
and is properly shielded.
If the problem persists, contact your dealer.
There are no static or impulse interference problems caused by nearby
The source changes randomly or freezes
power equipment switching, such as heating or air conditioning
on one source
control. Switch the receiver off, wait ten seconds, then switch it on
again to clear an operating problem. Contact your installer if the
problem returns or persists.
There is no direct sunlight shining on the infra-red detector behind the
front panel display.
The 'max on volume' setting is not set too high.
Volume is always too loud when I turn
on
The files are in a compatible format.
If files on a NAS drive cannot be played
The computer is connected via a network and not USB – the Receiver
USB port cannot be used for a direct connection to a computer
If you cannot connect to a wired network The Ethernet cable you are using is correctly connected between the
receiver and the network hardware.
The network is set up for fixed ip addressing and you have the Receiver
set to use DHCP.
The network is set up for DHCP and you have the receiver set to use
fixed IP addressing.
The station is still broadcasting or is not congested – try again later.
If you cannot connect to a favourite
internet radio station
The radio station has a low bit rate (use the
If the internet radio station sound quality
is poor or broken
The network is not slow or congested.
key to find this).
EN-39
EN