Morsø 1450 Instrucciones De Montaje página 8

Installation of soapstones for Morsø 1450 fig. 1-4
Fig. 1.
The enclosed  screws Ø8x0 mm should be fastened in the base of the stove into the same
holes that are used to fasten the appliance to the pallet.
Fig. 3.
When fitting the soapstone slabs, the enclosed  dowels should be placed in the holed joint
between the soapstone base and the side panel. The screws, Ø6x5 mm are then fitted with
washers and are pushed through the inside of the inner cast side panel of the stove into the
outer soapstone side where a bush is already fitted.
Note: Take care not to overtighten the screws as you may loosen the bush.
8
Fig. 2.
Fig. 4.