Information About The Batteries; Installation Of The Wall Bracket - Silvercrest SAST 18 A1 Instrucciones De Uso

Information about the batteries

■ The appliance runs on rechargeable lithium-ion batteries. Before using the
appliance for the first time, the batteries must be charged. The charge
indicator lamp
fully charged, the charge indicator lamp
■ If the charge indicator lamp
is almost completely discharged and the appliance switches off after approx.
1 minute. This protects the appliance from deep discharge.
NOTE
► The appliance is equipped with a temperature monitor to protect the
batteries. At high ambient temperatures (in rare cases) the charging
process may be interrupted or the appliance may switch off automatically:
–
The charging process is interrupted and resumes automatically as soon
as the temperature of the appliance has dropped.
–
The appliance switches off automatically and the charge indicator lamp
flashes green and red alternately for one minute. Allow the appliance to
cool for 20–30 minutes before switching it on again.

Installation of the wall bracket

DANGER! ELECTRIC SHOCK!
► Ensure that there are no power cables or water pipes in the wall at the
location where you intend to drill the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
1) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be a mains power socket nearby. In addition, there should be no power
or water lines in the wall.
2) Drill two holes below each other at a distance of approx. 110 mm from each
other. The drill holes must be suitable for 6 mm wall plugs.
3) Push in the wall plugs and screw in the screws so that the heads protrude a
few millimetres.
4) Hang the wall bracket
that the screws slide into the slots. The wall bracket
against the wall. You can adjust the distance to the wall and compensate for
any unevenness in the wall by screwing in or unscrewing the screws.
5) Ensure that the power cable is not trapped and that it lies properly in the
cut-out.
6) Push the two accessories holders
and right of the wall bracket
accessories holders
│ GB │ IE
■ 10
w
flashes red during charging. As soon as the batteries are
w
flashes alternately green and red, the battery
7
with the drill holes over the two screws and ensure
8
into the respective catches on the left
7
. You can place the nozzles in the
8
.
w
lights up green.
7
:
7
should lie flush
SAST 18 A1
w
7
.