Assembly - Attaching The Fan Blades; Attaching The Blades To The Blade Brackets - HAMPTON BAY 32711 Guía De Uso Y Mantenimiento

Assembly - Attaching the Fan Blades

1
Fastening the blade brackets to
the motor
WARNING: Remove the rubber motor stops on the bottom of
the fan before installing the blades or testing the motor.
IMPORTANT: The switch cup cover has an access hole (ZZ)
to allow the screwdriver to reach the screws in the blade
bracket. Position the blade bracket on the motor and tighten
by inserting the screwdriver through the access hole (ZZ).
NOTE: Your fan features revolutionary advancements for quick
and easy blade installation, including an alignment post and
captive blade bracket screws.
□
Fasten the blade brackets (H) to the fan-motor assembly (E) by
inserting the alignment post into the slot on the bottom of the
motor and tightening the pre-installed blade bracket screws
by inserting a screwdriver through the access hole (ZZ).
□
Repeat this step for the remaining blade bracket by rotating
the motor until the next blade bracket screw can be accessed
through the access hole (ZZ) in the switch cup cover.
2
Attaching the blades to the blade
brackets
□
Mount the fan blade (G) to the blade bracket (H) by aligning the
three key-slot holes in the blade (G) with the three posts on the
top of the blade bracket (H).
□
Hold the blade (G) with both hands close to the blade bracket
(H) and press down firmly. Ensure the key-slot holes are
properly seated on the blade bracket (H) posts.
□
While still holding the blade (G) down with both hands, slide
the blade (G) until it engages in the locking mechanism (UU).
Make sure the locking mechanism (UU) at the rear of the blade
bracket (H) springs upward and butts against the edge of the
blade (G), indicating a secure connection.
□
Visually inspect the top of the blade bracket (H) to ensure the
locking mechanism is securely in place.
□
Repeat this procedure for the remaining blades (G).
All manuals and user guides at all-guides.com
12
E
H
ZZ
E
UU
G
H