Assembly - Standard Ceiling Mount
1
Preparation for mounting
□
Remove the canopy ring (N) from the canopy (C) by turning
the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (LL) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (JJ) in the
round holes. This will enable you to remove the mounting
bracket (A).
LL
3
Assembling the fan
□
Loosen, but do not remove, the setscrew on the collar (K) on
top of the fan-motor assembly (D).
□
Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar (K) on top of the fan-motor
assembly (D).
□
Carefully insert the hanger pin (CC) through the holes in the
collar (K) and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews on the collar (K) on top of the
fan-motor assembly (D).
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
2
A
JJ
C
N
CC
7
Routing the wires
□
Route the wires exiting the top of the fan-motor
assembly (D) into the decorative motor collar cover (F)
and through the canopy ring (C).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
Please contact 1-855-HD-HAMPTON for further assistance.
C
B
F
D
B
DD
K
D
HAMPTONBAY.COM