Battery:
• Danger of explosion if battery incorrectly replaced.
• Replace only with the same or equivalent type recommend
• Dispose of used batteries according to the battery manufac-
Joystick or MIDI port:
• Do not use any joystick or MIDI device that requires more than
FCC and DOC Statement on Class B
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from
• Consult the dealer or an experienced radio TV technician for
Notice:
1. The changes or modifications not expressly approved by the
2. Shielded interface cables must be used in order to comply
lp 865pe 76330403 1.pmd
by the manufacturer.
turer's instructions.
10A current at 5V DC. There is a risk of fire for devices that
exceed this limit.
that to which the receiver is connected.
help.
party responsible for compliance could void the user's author-
ity to operate the equipment.
with the emission limits.
3
3/5/2004, 5:17 PM