Publicidad
Idiomas disponibles
Idiomas disponibles
TFA_No. 43.2038_Anleitung
LED-headlamp
Caution!
Risk of electrocution!
• Connect the device via the USB cable only to a suitable USB
power source.
• The product must not come into contact with water or moisture
while loading.
• Do not charge the product if the housing is damaged.
• Charge the device out of reach of persons (including children)
who cannot fully appreciate the potential risks of handling elec-
trical equipment.
• Disconnect the device from the charging power source immedi-
ately if any fault occurs.
WARNING!
Risk of injury!
• Do not shine light directly into eyes!
• Small parts can be swallowed by children (under three years
old).
• Batteries containing lithium carry a risk of fire or explosion due
to heat or mechanical damage!
• Protect it from high temperatures. Do not throw into fire, short-
circuit or take apart.
• If the device becomes hot while charging or the battery is no
longer charged, this is a sign of a defect. Disconnect the device
from the charging power source immediately.
• The battery cannot and must not be replaced or removed by
you. There is a risk of explosion if the battery is replaced in-
correctly. If necessary, a qualified person can obtain instruc-
tions on how to dismantle the permanently installed battery
from info@tfa-dostmann.de, should this be necessary for the
purpose of repairing or recycling the product.
CAUTION
• Unauthorised repairs, alterations or changes to the product are
prohibited.
• Do not expose the device to extreme temperatures, vibrations
or shocks.
• The instrument is not unbreakable. In case of falling down parts
can break.
29.06.2022
17:50 Uhr
– 10 –
Seite 6
LED-headlamp
• Clean the device with a soft damp cloth. Do not use solvents or
scouring agents.
5. Elements (Fig. 1)
A 1:
LED focus light
A 2:
COB light stripe
A 3:
Motion sensor with indicator light
A 4:
Motion sensor ON/OFF button
A 5:
ON/OFF button
A 6:
Charging status (4 indicator lights)
A 7:
USB-C port
6. Charging
• Pull off the rubber protection. Make sure that the rubber pro-
tection does not get lost. Plug the supplied USB-cable into the
designated port on the device and connect the unit to a suitable
USB power source.
• To fully charge, leave the device connected for approximately
2.5 - 3.5 hours.
• The device cannot be operated during the charging process.
• The battery's charge status is indicated by four LED indicator
lights.
• The first indicator light turns blue when the battery is charging.
As soon as all four indicator lights light up, the battery is fully
charged.
• Disconnect the device from the charging power source.
• As soon as the headlamp is powered on, the charging status
indicator lights up. The first indicator light flashes when the
battery needs to be charged.
• Please charge the device immediately to preserve battery life.
• Recharge the battery every six months, even if the product is
not in use.
• After charging, be sure to reseal the charging port with the
rubber protection.
7. Getting started/Operation
• Before the first use, please charge it fully.
• Press the ON/OFF button.
• The charging status indicator lights up.
• You can select your respective light setting by pressing the
ON/OFF button. The sequence is shown as follows:
– COB diffused light high
– 11 –
Publicidad
