Using The Appliance - HOMCOM 800-122V70 Instrucciones De Uso

USING THE APPLIANCE

The oil-free can prepare a large range of ingredients.
Hot air frying
1. Connect the mains plug into an earthed wall socket.
2. Carefully pull the pan out of the Hot-air fryer (Fig.4)
3. Put the ingredients on the Shelf. (Fig.5)
4. Slide the pan back into the Hot-air fryer (Fig 6)
Noting to carefully align with the guides in the body of the fryer.
Never use the pan without the basket in it.
Caution: Do not touch the pan during and sometime after use, as it gets very hot. Only
hold the pan by the handle.
5.Determine the required preparation time for the ingredient (see section 'Settings' in
this chapter).
6. To switch on the appliance, turn the timer knob to the required preparation time (Fig.7)
7.Turn the temperature control knob to the required temperature. See section 'Settings'
in this chapter to determine the right temperature (Fig.8).
Add 3 minutes to the preparation time when the appliance is cold.
Note: If you want, you can also let the appliance preheat without any ingredients inside.
In that case, turn the timer knob to more than 3 minutes and wait until the heating-up
light goes out (after approx. 3 minutes). Then fill the basket and turn the timer knob to the
required preparation time.
a. The timer starts counting down the set preparation time.
b. During the hot air frying process, the working light comes on and goes out from time
to time. This indicates that the heating element is switched on and off to maintain the set
temperature.
c. Excess oil from the ingredients is collected on the bottom of the pan.
8.Some ingredients require shaking halfway through the preparation time (see section
"Settings" in this chapter). To shake the ingredients, pull the pan out of the appliance by
the handle and shake it. Then slide the pan back into the I fryer.
Caution: Don't use the body the skin direct contact to shelf. (Fig.3)
Tip: To reduce the weight, you can remove the basket from the pan and shake the basket
only. To do so, pull the pan out of the appliance, place it on a heat-resistant surface and
press the button of handle. and lift the basket out of the pan
Tip: If you set the timer to half the preparation time, you hear the timer bell when you
have to shake the ingredients. However, this means that you have to set the timer again
to the remaining preparation time after shaking.
9. When you hear the timer bell, the set preparation time has elapsed. Pull the pan out of
the appliance and place it on the trial framework.
Note: You can also switch off the appliance manually. To do this, turn the time
control knob to 0.
10. Check if the ingredients are ready.
If the ingredients are not ready yet, simply slide the pan back into the appliance and set
the timer to a few extra minutes.
11. To remove ingredients (e.g. fries), pull the pan out of the Hot-air fryer and place it on
trial framework, and press the basket release button and lift the basket out of the pan.
Do not turn the shelf upside down with the pan still attached to it, as any excess oil
that has collected on the bottom of the pan will leak onto the ingredients.
the pan and the ingredients are hot and hot fryer. Depending on the type of the
ingredients in the I fryer, steam may escape from the pan.
EN