How To Use - Home 50386 Manual

function.
ො Do not use the diffuser continuously after the product powers off automatically. Please
wait 60 minutes before using it again to avoid damage to the ultrasonic plate. Use
tap water only, do not use mineral water, or sparkling water or other kinds of water.
ො The amount and intensity of the mist produced will vary, but this is not unusual and
should not be considered as a fault.
ො Factors that can affect: water type, humidity, temperature and air currents.
ො Never move the diffuser when in use.
ො Do not touch any part of the diffuser with wet hands.
ො If smoke or a burning smell is detected coming from the unit, unplug immediately.

2. HOW TO USE

1. Place the diffuser in an upright position and remove the upper cover (FIG 1).
2. Connect the AC adapter cable to the DC jack of the diffuser (FIG 2).
3. Use the measuring cup to fill the diffuser with water. Please take care not to spill
water (FIG3).
- Pay attention to the water level when filling. Do not exceed the max. line on the
water tank.
- Never fill with water when the diffuser is in operation.
1. Light
2. Mist
3. Drainage outlet
4. Water tank
5. Base
6. Air outlet
7. D.C. Socket
8. Water outlet
9. Air inlet