Publicidad
Idiomas disponibles
Idiomas disponibles
Battery Level Indicator Icon (3):
Full charge
3/4 battery level remaining
1/2 battery level remaining
1/4 battery level remaining
Battery icon blinks - battery needs to be replaced, and the unit will not be operable.
BASIC OPERATION
• To activate the laser rangefinder, press and release the Power/Fire button to show the display.
• If the display appears blurry, rotate the rubber eyecup/diopter adjustment in either direction until the display is sharp
for your vision.
• Placing the aiming circle (located in the center of the display) on a target at least 5-6 yards away, depress and hold the
Fire button down until the range reading is displayed below the aiming circle.
• Once a range is acquired, you can release the Fire button. The four "crosshairs" just outside the aiming circle will go out,
indicating the laser is no longer transmitted. The display will remain on and display the last distance measurement
for about 10 seconds until the display automatically switches off to extend battery life.
• You can press the Fire button again at any time to check the range to a new target. To re-fire, press the button again.
• To scan the laser across an area and get continuously updated range readings, continue to hold the Fire button
down and sweep the rangefinder over multiple targets. The crosshairs outside the aiming circle will flash to indicate
scan operation.
DISPLAY INDICATORS/ICONS
The Prohunter rangefinder's display incorporates the
following illuminated indicators:
1. Bow Mode
2. Battery Level Indicator
3. Aiming 12 MOA Circle/Dot
4. Primary Numeric Display displays Line-of-sight Distance
5. Range (Distance) Units (12): Y=Yards, M=Meters
6. Secondary Numeric Display
(True Horizontal Distance for Bow Mode)
7. SETUP Mode
8. Angle Indicator
Regular Mode with Automatic SCAN (LCD Indicator – none) This setting allows most targets to range up to 750 yards. This
setting is used for moderately reflective targets that are typical of most distancing situations. The minimum distance in the
standard mode is five yards. To use the Automatic SCAN feature, press and hold the Fire button, then move the rangefinder
from object to object while keeping the Fire button depressed. Automatic SCAN will allow the range to be continuously
updated as multiple objects are targeted. Crosshair lines flash while scanning.
TILT™ Mode
The Prohunter Laser Rangefinder with TILT™ is designed with hunters in mind. Your Prohunter rangefinder features a built-
in inclinometer that solves a problem hunters have had for years. Bowhunters have struggled with extreme uphill and
downhill angles because of how these angles alter true horizontal distance to your target. The TILT™ solution: an integrated
inclinometer provides angular data to a processor chip when targeting either uphill or downhill objects. This data is combined
with internal algorithmic formulas. The user-selectable TILT™ modes allow you to adjust the performance parameters of the
unit to suit your specific situation and environment.
Along with the standard "line of sight" distance, when the Fire button is released, the Prohunter laser rangefinder's display
can also show you the true horizontal distance (TILT™ MODES section). For example, a bowhunter in a tree stand may aim
at a downhill deer at a -52o relative to his position. The line of sight distance is 32 yards, but he is likely to "overshoot" the
target based on that. The THD distance (compensated for the angle) reads 23 yards. That is the distance the hunter should
base his shot.
2
8
3
7
1
4
5
6
3
Publicidad
