Remote Control Battery Replacement - Sangean DDR-43+ Manual De Instrucciones

Remote control battery replacement

1. Remove the battery cover on the rear of your remote control by
applying pressure to the catch in the direction shown by the arrow in
the diagram, and then lifting the cover.
2. Insert 2 x AAA size batteries into the compartment. Make sure the
(+) and the (-) ends of the batteries are positioned as shown inside
the compartment.
3. Close the battery cover by inserting the retaining lugs first,
then apply pressure to the free end such that the catch latches
the cover securely.
4. If the remote is not to be used for an extended period of time it is
recommended that the batteries are removed.
IMPORTANT:
The batteries should not be exposed to excessive heat such
as sunshine, fire or the like. After use, disposable batteries should
if possible be taken to a suitable recycling centre. On no account
should batteries be disposed of by incineration.
1. Battery compartment
2. Latch
3. Retaining lugs (inside)
GB
7