Seko PoolMatch pH Manual De Instalación página 7

PoolMatch | pH · ORP
Save and exit Program setup – Press
Pressing the key determines the exit from the programming menu with saving of the parameters, if the
parameter of the menu item in which one is in has not been changed when pressing the
Set Point adjustment
Press the button for 3 seconds, use
Stand-by mode (backlight on)
Press and buttons simultaneously for 5 seconds to switch off the unit backlight. Dosage and
calibration are disabled. To exit standby, press
Priming
Only while the pump is in stand-by press down
Flowrate counter reset
To reset value of "Permanent Totalizer" press
Offset/Slope Menu
Press and buttons the unit show Offset/Slope calibration value, press
menu.
pH/ORP
measure
Alarm list
-
LEV
-
WDG
-
OFA1 & OFA2
-
Stand By
-
Flow
0000138883
and to set the desired value.
and buttons simultaneously.
and in the same time.
button for 3 seconds, in stand-by mode only.
rev. 1.0 EN
or
Temperature
measure
°
Flowater totalizer
Absolut
Resetable
key.
to scroll the
5