Gas Connection - CORBERO CPCGM5F5021 N Manual De Usuario

(A) SEALING STRIP
(C) SCREW

Gas Connection

Gas supply replacement and installation guidelines:
o It is the law that all gas appliances are installed by competent persons in
accordance with the current edition of the Gas Safety Installation and
Use Regulations .
o It is in your interest and that of safety to ensure compliance with the law.
o In the UK, GASSAFE registered installers work to safe standards of
practice. The hob must also be installed in accordance with the current
edition of BS 6172. Failure to install the cooker correctly could invalidate
the warranty, liability claims and lead to prosecution.
Gas category, gas type and destination country (for all models)
. 2 Carefully turn the hob back over and then gently lower
. 3 On the underneath of the hob, adjust the brackets into
(B) BRACKET
natural
LPG > NG
The gas rail
seal
G1/2"Female coupler
Do not use a silicon sealant to seal the
appliance against the aperture.
of the screws.There are one set of screw holes in each
corner of the hob (H) .
Slightly tighten a screw (C) through the bracket (B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
it into the aperture hole that you have cut out.
a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob into
position.
LPG and natural gas. Conversion for
18
NG > LPG
The gas rail
seal
Ø11.5 Female coupler