universalblue UBLAV2702-21 Manual De Instrucciones página 86

Low water
pressure
Non
fucnion
drainage
pump Overflow
Normal
noise during
operation of
the device
Incorrectly
Noise
placed
utensils
Engine noise
Foam in
the tray
Incorrect
detergent
Stains
inside the Incorrect
dishwasher detergent
Incorrect
program
Dirty Placing the
crockery correct
and cutlery tableware
Stains on
Water too
glassware
hard
or cutlery
Low water
temperature
Make sure that the water inlet hose is
correctly positioned and the water faucet is
open.
The device is designed to detect overflow
problems
The device does not present any problem
when normal operating sounds are heard
(running water, detergent dispenser
opening...).
Before operating the dishwasher, make sure
that the dishes and utensils have been
placed correctly.
The dishwasher has not been used regularly.
In that case, try to turn it on at least once a
week to ensure proper operation.
Use only detergents designed for the
dishwasher. If foam is detected it is
recommended to open the dishwasher door
and wait until the foam disappears.
Add 1 litre of cold water to the flask, close
the dishwasher and start the appliance with
the pre-wash program.
Make sure that the detergent used is
suitable and does not contain dyes.
Select a more intense program
Place the tableware correctly as shown in
the corresponding section.
- Remove all metal utensils from the
appliance
- Do not add detergent-
Select the longest program-
Let the program run for 18 to 22 minutes-
86