Changing The Roller Brushes - Solamat 100/150; Changing The Disc Brushes - Solamat 100/150/200; Changing The Disc Brushes - Solamat 100/150 - HEUTE Solamat 90 Manual De Instrucciones

Changing the roller brushes –
Solamat 100/150/200
In principle identical to the process with the Solamat 90. First
detach the front panel by releasing the 11 hexagon socket screws
(width across flats 3 mm). Additionally remove round belt no. 4
(size 650V) from the upper round belt pulley (see Fig. 8).
Fig. 8
Changing the disc brushes – Solamat 90
Disassemble the motor mounting (see chapter Service and
1.
repairs > Disassembling the motor mounting).
Remove round belt no. 1 (710 V) and no. 3 (700 V)
2.
(see chapter Service and repairs > Belt change -
Solamat 90). Prior to removing the belts, mark these to ensure
that they cannot be confused during installation.
Set the motor mounting to the side.
3.
Loosen the self-locking nuts, which clamp the disc brush onto
4.
the shaft. In order to do so it is necessary to secure the axle
with a fitting pin to prevent it from rotating (see Fig. 9).
Release the 2 bearing rings (hexagon socket screw, width across
5.
flats 2.5 mm) (see Fig. 10).
Turn out the axle until the brush is free and can be removed.
6.
Carry out installation of the new brushes in reverse order.
7.
The disc brushes must have 1-2 mm play to the screw heads
(see Fig. 11). They must be secured on the shaft once more
using new self-locking M10 nuts.
Installation of the motor mounting takes place in reverse
8.
order to the deinstallation (see chapter Service and repairs >
Disassembling the motor mounting).
Check to ensure electrical safety following installation.
9.
Fig. 9
18
Fig. 10
Fig. 11

Changing the disc brushes - Solamat 100/150/200

In principle identical to the process with the Solamat 90. First
detach the front panel by releasing the 11 hexagon socket screws
(width across flats 3 mm). Additionally remove round belt no. 4
(size 650V) from the upper round belt pulley (see Fig. 8).