DJI Agras T40 Guia De Inicio Rapido página 3

and arms are unfolded, and the arm locks are firmly fastened.
C. Make sure that the spray tank and flight battery are firmly in place.
D. Pour liquid into the spray tank, and tighten the cover.
E. Power on the remote controller, make sure that the DJI Agras app is open, and power on the aircraft.
● When using for the first time, activate the aircraft using the DJI Agras app. A DJI account and internet connection are
required.
Calibrating the Flow Meter
Make sure to calibrate the flow meter before using for the first time. Otherwise, the spraying performance may be adversely
affected.
① Fill the spray tank with approximately 10 L of water.
② In the app, go to Operation View. Tap
section.
③ Tap Start Calibration and calibration will start automatically. The result of the calibration will be displayed in the app when completed.
●Users can proceed once calibration is completed successfully.
●If calibration fails, tap "?"to view and resolve the problem. Afterwards, recalibrate and wait for successful calibration.
Flight
In the app, go to Operation View. Make sure that there is a strong GNSS signal and the system status bar indicates Ready (GNSS) or Ready
(RTK).* Otherwise, the aircraft cannot take off.
* RTK positioning is recommended. In the app, go to Operation View, tap
method for receiving RTK signals.
Takeoff
Perform a Combination Stick Command (CSC) and push the throttle stick up to take off.
OR
Landing
To land, pull down on the throttle stick to descend until the aircraft touches the ground. There are two methods to stop the motors.
Method 1: when the aircraft has landed, push and hold the throttle stick down. The motors will stop after three seconds.
Throttle Stick
Method 2: When the aircraft has landed, push the throttle stick down, and perform the same CSC that was used to start the motors. Release
both sticks once the motors have stopped. Release both sticks once the motors have stopped.
● Spinning propellers can be dangerous. Stay away from spinning propellers and motors. DO NOT start the motors in
confined spaces or where there are people nearby.
● Maintain control of the remote controller as long as the motors are running.
● DO NOT stop the motors mid-flight unless in an emergency situation where doing so will reduce the risk of damage or
injury.
● It is recommended to use Method 1 to stop the motors. When using Method 2 to stop the motors, the aircraft may roll over
, then , swipe down, and tap Calibration on the right of the flow meter calibration
, then RTK to enable Aircraft RTK Positioning, and select a
Throttle Stick (left stick in Mode 2)