NSK Primado2 Manual De Operación página 44

Mounting and Removing the Adaptor for Oscillating Intra Oral Blade (Optional)
_ Mounting
1 While pulling down the Removal Lever Ⓐ, fit the concave part of
the Adaptor for Oscillating Intra Oral Blade Ⓓ into the convex
part of the Attachment Ⓒ.
Ⓓ
Ⓒ
2 Release the Removal Lever Ⓐ to set the Adaptor for Oscillating
Intra Oral Blade in place.
_ Removing
Perform steps 1 and 2 of the mounting procedure in the reverse order.
Mounting and Removing the Cutting Accessories (Optional)
1 Ensure the Screw part of the Adaptor for Oscillating Intra Oral
Blade Ⓕ and Notch Section on the Cutting Accessory Ⓔ are
located (12 o-clock) upward. Then insert the Cutting Accessory
into the Adaptor for Oscillating Intra Oral Blade.
2 Rotate the Special Wrench Ⓖ provided with the Adaptor in the
side hole of the Adaptor to set the Cutting Accessory Ⓗ in place.
Ⓗ
_ Removing
Perform steps 1 and 2 of the mounting procedure in the reverse order.
Ⓐ
Ⓐ
Ⓕ
Ⓔ
Ⓖ
3 By twisting the Removal Lever Ⓐ clockwise and
counterclockwise, set the Cutting Accessory in place properly.
* If the Cutting Accessory is not set in place properly, repeat the
procedure from 1 - 3 to set it in place properly.
3 After mounting the Cutting Accessory Ⓗ, pull it lightly to confirm
that it is securely connected to the Attachment.
* If the Cutting Accessory is not set in place properly, repeat the
procedure from 1 - 3 to set it in place properly.
43
Operation of BMH Series
Ⓐ
Ⓗ