4/ Installation - Selecline TAC-07CPB RM Manual Del Usuario

4/ INSTALLATION

• Unpack all parts.
• Check for completeness and shipping damage immediately after unpacking. If
your shipment is damaged or incomplete, please contact our customer service.
• Insert 2 AAA 1.5 V batteries into the remote control, make sure the battery polarity
is correct.
Select the location
• The air conditioner should be placed on a rm foundation to minimize noise and
vibration.
• The air conditioner should be placed near a window to assemble the exhaust hose.
• For safe and secure positioning, place the air conditioner on a smooth, level oor
strong enough to support it.
• The air conditioner has castors to aid placement, but it should only be rolled on
smooth, at surfaces. Use caution when rolling on carpeted surfaces or wood
oors.
• The air conditioner must be placed within reach of a properly rated grounded
socket.
• Never place any obstacles around the air inlets or outlets of the air conditioner and
do not cover the appliances' intakes and outlets.
• Allow at least 45cm of around and above space away from the wall for e cient
working.
• The hose can be extended, but it is the best to keep the length to minimum
required. Also make sure that the hose does not have any sharp bends or sags.
45 cm
Install the exhaust hose
In the cool mode the air conditioner must be placed close to a window or opening so
that the warm exhaust air can be discharged outside.
1. First position the air conditioner on a at oor and make sure there's a minimum
of 17.7" (45cm) clearance around the unit, and is within the vicinity of a power
source.
2. Extend either side of the exhaust hose and connect the hose inlet and hose outlet
to the two ends of the exhaust hose.
11
EN