5/ Use - Selecline TAC-07CPB RM Manual Del Usuario

Notes:
-
The window slider kit has been designed to t most standard vertical and
horizontal window applications, however, it may be necessary for you to modify
some aspects of the installation procedures for certain types of windows. The
window slider kit can be fastened with screws.
-
If the window opening is less than the minimum length of the window slider kit,
cut the end without the hole in it short enough to t in the window opening.
Never cut out the hole in the window slider kit.
Insert the exhaust hose through the window slider hole
A x the exhaust hose outlet into the window slider and seal them tightly.

5/ USE

The appliance can be controlled with the control panel or with the remote control. On
the following pages, operation is mainly described when using the remote control.
1. Plug the air conditioner to an outlet, the appliance goes into standby mode.
2. Press the button to turn on the air conditioner.
3. Never turn the air conditioner o by unplugging from the mains. Always press
the button, then wait for a few minutes before unplugging. This allows the
appliance to perform a cycle of checks to verify operation.
Notes:
-
To ensure the receiving e ect, the remote control must be no more than 7 meters
away from the air conditioner, and there should be no obstacles between the
remote control and the receiver.
-
Protect the room from direct exposure to the sun by partially closing curtains
and/or blinds to make the appliance much more economical to run.
-
Make sure there are no heat sources in the room.
Cool mode
• This mode is ideal for hot muggy weather when you need to cool the room.
• To set this mode correctly: Press the
indicator lights up.
• Select the target temperature18°C-32°C (64°F-90°F) by pressing the
button until the corresponding value is displayed.
• Select the required fan speed by pressing the
high, the temperature drops down fast. When the fan speed is low, the temperature
drops down slower and the fan will run with lower noise.
-
The most suitable temperature for the room during the summer varies from 24 °C
to 27 °C. You are recommended, however, not to set a temperature much below
the outdoor temperature. This will cause unnecessary power consumption.
Cut on opposite of hole
button a number of times until the cool
button. When the fan speed is
13
EN
or