Gardena ProCut 800 Manual De Instrucciones página 14

8851-20.960.02_12.11.2008:GARDENA
Put the trimmer in the
working position:
D
F
G
Starting the trimmer :
I
J
Filament feed
(Tip mechanism) :
3
14
27.11.2008
All manuals and user guides at all-guides.com
Try to ensure that the cutting filament does not come into
excessive contact with hard objects (walls, stones, fences
etc.) to prevent the filaments fusing together or snapping.
1. Fit the carrying strap
E
the hole
3 holes).
2. Put the strap
adjust it to your size.
3. Hold the trimmer by the top
of the handle
tional handle
so that the cutting head
tilted slightly forward.
A
ProCut 800 only :
E
1. Undo the tightening nut
push the additional handle
H
into the required place and
tighten the nut
2. Press the push buttons
handle to the required angle
again.
Switching the trimmer on :
1. Press and hold the safety
I
lock and then press the
start button
2. Release the safety lock
again.
Switching the trimmer off :
v Release the start button
on the handle.
The tap mechanism works when the motor is running. A clean
cut is only achieved with the maximum filament length.
1. Start the trimmer.
2. Hold the cutting head
parallel to the ground and
tap the trimmer with the
cutting head
ground (avoid sustained
pressure).
The cutting filaments
switching sound. The filament limiter
correct length. If necessary tap several times one after the other.
16:26 Seite 14
D
into
(ProCut 1000,
D
around you and
A
and the addi-
F 5
or handle
3
is
G
,
F
G
by hand.
H
on both sides. Set the additional
F
and release the push buttons
J
on the handle.
I
J
J
3
3
on the
1
lengthen automatically with an audible
K
adjusts the filament to the
I
K
1