AGV K1 Guia De Inicio Rapido página 8

1
3
1
4) ACCESSORIES
WARNING:
Only use original AGV accessories. To know which are the original AGV accessories go to www.agv.com.
The use of non-original accessories may compromise the safety of the helmet and will render all product war-
ranty null and void. Dainese Spa shall reject all responsibility in case of use of non-original accessories (e.g.
communication systems, action camera, visors and other accessories).
14
3.2) Removing/fitting the wind-proof chin
strap protection
To fit the fabric protector, mesh the teeth on the chin
guard with the edge of the base (1).
To remove the protector, slide it upwards and pull out
by one end.
2
4
3.3) Removing/Fitting the crown pad
To remove the crown pad, undo the buttons at the front
(1) then at the rear (2).
Reverse the process to fit the pad.
2
5) FASTENING SYSTEMS
There are three types of fastening systems:
- DD ring fastening
- Quick release mechanism
- Micrometric fastener
Below are the instructions for using these three systems.
1
2
3
5.1) DD ring fastening
To fasten the helmet, pass the
strap between the two rings (1),
pull the end of the strap (2) until
the belt presses against your jaw
and fasten the press-stud (3), as
shown in the diagram.
Check that the helmet is secure
(see also the section entitled
"Choice of appropriate helmet" in
the "Safety Warning" booklet).
To loosen the helmet, undo the
press-stud by pulling the end of
the strap and loosen the strap
through the rings, using the red
tab, as shown in the diagram.
15