Work Area Safety; Electrical Safety; Personal Safety - Temper KCB-240 Manual De Instrucciones

KCB 240-ST
Battery Crimping Tool
GENERAL SAFETY RULES
TO WORK IN SAFE CONDITIONS WITH THIS TOOLING, IT IS IMPERATIVE TO
READ CAREFULLY THE DIRECTIONS FOR USE AND TO FOLLOW THE
INSTRUCTIONS IT CONTAINS. IF YOU DO NOT RESPECT THE INFORMATION
WRITTEN IN THAT INSTRUCTION MANUAL THE WARRANTY WILL BE
CANCELLED.

1. Work area safety

a. Keep work area clean and clear. Cluttered or dark areas invite accidents.
b. This tool is not insulated; please do not use it on live conductor.
c. Please do not use or store the tool under high temperature, or one surrounding
filling with corrosive fluid. Pay attention to the sealing kits becoming aging.
d. Keep children and bystander away while operating the Battery powered cutting
tool. Distractions will cause you to lose control.
e. Do not use or charging the tool around flammable, explosive environment

2. Electrical safety

f. Make sure the plug matches with the plug seat. Never try any changes on the
plug.
g. Do not put tool, battery and charger under a rainy or humid surroundings, it is
easy to trigger an electric shock accident if any water goes into the electric
system of the tool.
h. Do not use electric wire to carry, pull, or to draw out the plug and do not connect
the ―-‖and ―+‖, the damaged or twined wire may cause an electric shock accident.
i. If the charger was strongly crashed, or dropping down or any other damages
happening, please do not try to repair it by yourself, send it back to the authorized
service center as soon as possible. The damaged charger may cause an electric
shock accident.
j. The best temperature for charging is between 10℃-40℃. Make sure the air hole
of the battery and charger are uncovered during charging.
k. Please cut off the power of the charger each time to reduce the hazard from child
or the person who not expert on the tool.
l. Do not wait until the battery runs over for recharging, the recharging will caused
the battery does not working anymore. Please keep the battery out of the tool to
avoid the power discharge.
m. Please do not burn the battery or make it being short-circuited, it may cause
explosion.
n. Do not use the waste battery otherwise it will caused the electric shock.
o. Do not disassemble the battery and charger. If any problem please contact with
manufacture or agent.

3. Personal safety

p. Stay alert, watch what you are doing and use common sense when operating the
tool. Do not use the tool while you are tired or still under the influence of drugs,
alcohol or medication. A moment of inattention may result in series personal
injury.
q. Use safety equipment. Always use safety equipment such as mask, helmet, safety
cap, insulating shoes and etc to reduce the risk of personal injury.
r. Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing
and gloves away from moving parts. Loose clothes jewelry or long hair can be
caught in moving parts.
s. Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the tool operation. If
damaged, have the tool repaired before use. Many accidents are caused by poorly
maintained power tools.
t. Please use the tool properly, the tool with correct power will do the job better and
safer at the rate for which it was designed.
u. Do not put your fingers into the head of the tool during operating. Your fingers
www.grupotemper.com