Temper KCB-240 Manual De Instrucciones página 17

KCB 240-ST
Battery Crimping Tool
Power off
Press
automatically.
USB pot with Take the battery away from the tool, connect the USB with a
computer
computer to exchange the data. LCD showing symbol
Make sure that all the parts are clean without any oil, dust, especially on the
handle and control parts, to avoid the tool drop easily during the operation.
First press the for 3 s to turn on the power, the tool on the self inspecting for
1 s. the data will show last record, the tool is ready for working.
1) inspect the battery saturated or run out.
Don't operate the tool without blade.
2) Open the head by pull out the pin, then the cable/conductor must be positioned in the
cutting head which must be closed thereafter.
3) A cutting process is initiated by switching the trigger. It is defined by the approach and
penetrate on of the moving blade into the cable/conductor. The moving blade must
approach the cable/conductor from a vertical direction to avoid undesired shearing
forces which might cause the blade to stuck or get damaged.
4) A cutting cycle is terminated when the blades closed completely or when the
maximum cutting force is reached.
The cutting process can be interrupted at any moment by half releasing the trigger,
but the piston keep paused at moment.
Do not put your fingers into the head of the tool during operating. Your fingers could
be pinched very severely.
for 3 s or leave the tool 30 mins to off the power
www.grupotemper.com