Symptom
NO DETERGENT
GARDEN HOSE
CONNECTION
LEAKS
SPRAY WAND
LEAKS
PUMP IS NOISY
WATER LEAKS
FROM PUMP (UP
TO 10 DROP PER
MINUTE IS PER-
MISSIBLE)
OIL DRIP
If the symptom you are experiencing is not listed
above, or if the provided solutions do not solve your
issue, please visit our extensive online trouble-
shooting database at:
www.karcher-help.com or www.karcher.com/ca/
support/faqs.html
TROUBLESHOOTING
Cause
Filter on detergent suction
tube is clogged
Damaged or clogged deter-
gent suction tube
A high pressure nozzle is
attached
Spray nozzle is obstructed
Loose fittings
Missing/worn rubber
washer
Spray wand not properly
attached
Broken o-ring or plastic
insert
Not enough water supply
Loose fittings
Water seals are damaged
or worn.
Thermal protection device
is activated.
Oil seals are damaged or
worn
Solution
Run warm water through filter to remove
debris
Remove obstruction or replace detergent
suction tube
Replace with black detergent nozzle
Blow out or remove debris with fine needle
Tighten fittings
Insert new washer
Turn the swivel nut of the gun clockwise until
connection is tight
Call listed support phone numbers in Cus-
tomer Service section.
Visit www.karcher-help.com or locate a ser-
vice center at www.karcher.com/us or www.
karcher.com/ca
Check that hoses and fittings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through the nozzle
Check fittings
Visit www.karcher-help.com or locate a ser-
vice center at www.karcher.com/us or www.
karcher.com/ca
Thermal protection device will auto reset.
Do not run pump for more than 5 minutes
without spraying
Visit www.karcher-help.com or locate a ser-
vice center at www.karcher.com/us or www.
karcher.com/ca
17