Roadstar PCD-498NMP Manual De Instrucciones página 4

1 English
LOCATIONS OF CONTROLS
1. LCD DISPLAY
2. PLAY/PAUSE
3. STOP
4. SKIP -
5. SKIP +
6. PROGRAM
7. MODE
8. OPEN
9. CD DOOR
10. VOLUME KNOB
11. HEADPHONES OUT
12. DC INPUT JACK
13. RECHARGE SWITCH
14. BATTERY COMPARTMENT
POWER SUPPLY
USE WITH REGULAR BATTERIES (NOT INCLUDED)
1. Open the battery compartment door, located on the bottom of the unit, by sliding
the door and lift it up. (Do not remove the battery door);
2. Insert 2 x 1.5V /UAM-3/AA size alkaline batteries, following the correct polarity, as
indicated in the battery compartment;
3. Close the battery compartment door. If the symbol "LOW BATTERY" appears in
the display, batteries are weak and ought to be replaced.
USE WITH AC/DC ADAPTOR (NOT INCLUDED)
1. Insert the DC plug, at the end of the AC/DC adaptor cord, into the DC 5 V INPUT
socket (12) located on the back of the unit;
2. Connect the AC/DC adaptor into a 100-240V ~ 50-60 Hz AC power outlet.
Notes:
If the AC adaptor is connected when regular batteries are installed, the power
•
supply automatically switches to the AC power source.
Use only the supplied AC/DC adaptor. Using other types of adaptor may da-
•
mage the unit.
Make sure that the AC/DC adaptor matches with your household voltage befo-
•
re connecting it into the wall outlet.
When not using AC power, disconnect the AC/DC adaptor from the wall outlet.
•
Do not touch the AC/DC adaptor with wet hands.
•
USE RECHARGEABLE BATTERIES (NOT INCLUDED)
1. Disconnect the AC/DC adaptor from the wall outlet if it is being connected to the
unit;
2. Open the battery compartment door as mentioned previously;
3. Insert 2 recommended rechargeable batteries, following the correct polarity as in-
dicated in the battery compartment;
4. Close the battery compartment door;
5. Connect the AC/DC adaptor to the wall outlet;
6. Move the RECHARGE SWITCH (13) to ON to start recharging function;
7. After 15 hours of charging set the RECHARGE SWITCH (13) to OFF.