Place the washer on the guide bar from the
outside of the bracket and secure the guide
bar using the split pin.
Attach the chain to the rear left leg using an
M8×50 bolt, two washers and a nut in the
outer link of the chain.
Attach the protective shield on the inner
blade guard to the blade guard using an M5
nut and two washers.
70
Stop plate (Fig. J)
Attach the stop plate using an M5×10 Phillips
screw, a spring washer and a washer on each
side.
Cover (Fig. K)
Mount the cover (14) on the cradle (4) using
four M5×10 screws and four lock nuts.