Cleaning And Maintenance - Grouw 18224 Manual De Instrucciones

7. Hold the outer fl ange with one spanner
and remove the M20 nut using the other
spanner. Remove the outer fl ange and
saw blade from the motor shaft.
8. Fit the new saw blade and reassemble
the saw by following the steps above in
the reverse order.
NB! Make sure to turn the saw blade
correctly!
Check that the blade's safety devices work
properly before using the saw again.
74

Cleaning and maintenance

Remove sawdust and dirt using a vacuum
cleaner, compressed air or a brush
immediately after each use. Check that the
motor ventilation slots are not blocked.
The saw can be cleaned by wiping its exterior
parts with a damp cloth.
Lubricate the moving parts with oil from time
to time. In the event of prolonged storage,
we recommend lubricating the saw blade
and the guide bar with oil to prevent rust. Do
not spray oil or lubricant into the motor.
Never use strong or corrosive detergents on
the log saw. They can damage the parts of
the saw and aff ect its function.
Cover the saw with a tarpaulin if it is
outdoors and ensure that the motor and
on/off button are protected against water.