PowerStroke PS14120 Guía De Referencia Rápida

WARNING:
This Quick Reference Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product. All page references refer to
the operator's manual.
FIRST TIME ASSEMBLY
1 Attach the handle assembly (see page 10).
2
Install the spray wand (see page 10).
3 Connect the high pressure hose to the trigger handle (see page 10).
4 Connect your garden hose to the pressure washer (see page 10).
Completely uncoil garden hose or remove completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger to relieve air pressure. Hold the trigger until a steady stream of
water appears.
PS14120 QUICK REFERENCE GUIDE
STARTING THE UNIT
1 Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
ready for operation (see page 11).
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 3 and 8).
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length
100 ft.
NOTE: A.W.G. = American Wire Gauge
2 Press switch ON to start the motor (see page 11).
SWITCH
ON
3
When finished, press switch OFF to stop the motor (see page 11).
SWITCH
OFF
Pour pressure washer
1
detergent in detergent tank
(see page 13).
Use of soap nozzle will activate detergent injector at a 20:1 dilution ratio.
Wire Size (A.W.G.)
25 ft. 14
50 ft. 12
Not Allowed
Use the chart below to determine the correct nozzle for your job.
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
Add Pump Protector to the unit after each use and before storing. This will significantly improve pump
1
life.
To order Pump Protector, call customer service at 1-877-617-3501.
To add, follow the instructions provided by the Pump Protector manufacturer.
(See page 14.)
USING DETERGENT
Install blue or black soap Squeeze trigger and wait
2 3
nozzle (see page 12). approx. 5 seconds for soap
(see page 13).
5 S
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
NOZZLE SELECTION GUIDE
LOW PRESSURE
HIGH PRESSURE
(NO SOAP WHEN USING THESE NOZZLES)
Turbo Nozzle 5º
 
 
 
 
 Recommended Nozzle Use With Caution for Certain Applications

BEFORE STORING THE UNIT
(FOR SOAP OR
GENTLE RINSE)
Blue or Black
Soap Nozzle




PUMP
PROTECTOR
991000058
6-4-14 (REV:01)