Prolonged Periods Of No Use; Faults, Alarms And Breakdowns - Fagor M-G910 Instrucciones De Instalación, Uso Y Mantenimiento

Ocultar thumbs Ver también para M-G910:

Instrucciones generales para la instalación, uso y mantenimiento (52 páginas)

Contenido

Idiomas disponibles

•

It is advisable to regularly clean the inner part of the tub with soapy water that is left to boil

for a few minutes. and then rinse it with plenty of water. Then rinse it with plenty of water

and dry.

•

After use, all the models require regular greasing of the drainage tap with "KLÜBER

NONTROP PLB DR" or similar grease to prevent it from seizing up and to prevent possible

leaks.

•

A screw is located on the lower part of the pot of the Bain Marie models to empty the

chamber completely.

If the power cable is damaged, it must be replaced by the manufacturer, after-sales service or

authorised technical personnel in order to prevent risks.

5.3.3

Prolonged periods of no use

If the machine is kept out of service for a long period of time (holidays, temporary closure, ...),

please observe the following:

•

Close the gas supply.

•

Clean the machine and the adjacent areas thoroughly.

•

Spray a thin layer of edible oil over the stainless steel surfaces.

•

Switch off the mains power supply.

6. FAULTS, ALARMS AND BREAKDOWNS

The steps to be followed in the event of a fault or operating error are described below. The possible causes

and possible solutions are listed in the following table. In the event of doubt, or if you are unable to resolve

the problem, please contact the technical service.

Do not handle electrical components, as there is a risk of death as the components are

live.

Problem

Smell of gas

Ignition pilot does not light.

Ignition pilot goes out.

Flame is yellow.

Cooking pot does not heat up

(*) in Bain Marie pots

Cause

Occasional gas leak caused by

flame going out.

Spark generation does not work.

Air in pipes due to long period of

inactivity.

Thermocouple not heated enough.

Dirty burner

Broken valve

Energy control broken

Insufficient pressure in the chamber

(*)

Pressure switch broken (*)

TLimiting thermostat trips (*)

Insufficient gas pressure.

Solution

Close the gas supply and ventilate

the premises.

Manually switch on the cooking pot.