Handling Precautions - Fluke touch device Informacion General

Handling precautions

The touch device and the sensALIGN heads (sensor and laser) are
precision instruments and should not be dropped or subjected to
physical shock.
Storage
Use the provided case to transport the system.
If the sensALIGN 7 heads are mounted on standard brackets while
within the case, the clamping levers must remain in the "open"
position and not locked.
If the sensALIGN 5 heads are mounted on standard brackets while
within the case, do not turn the brackets upside down when removing
them from the case. This reduces the risk of the components crashing
to the ground in case the locking knobs have not been tightened.
If the system is not used for an extended period, remove the related
batteries from the components and store both the batteries and the
components in a cool, dry and well-ventilated location.
Note: The sensALIGN 5 sensor rechargeable battery is integrated
with the sensor and therefore non-removable.
Observe the storage temperatures specified in the "Safety
specifications" section.
Care
All optical surfaces (laser aperture, sensor lens) must be kept clean.
Use the supplied lens cleaning cloth. Avoid vigorous polishing to
preserve the anti-reflective coatings of the glass elements. The touch
device housing may be wiped clean using a soft cloth dampened
with a mild, non-abrasive detergent (use soapy water with only
1% mild soap in water). The display should be cleaned using a soft
lint-free dry cloth.
Maintenance
Although the system is essentially maintenance-free, the following
points should be observed:
 The calibration accuracy of both sensor and laser should be
checked every two years as indicated by the coloured date
wheel label affixed to the respective housings.
 Please return the sensALIGN heads to your authorized
PRÜFTECHNIK service center for inspection by the date
indicated.
Disposal
Any waste electrical and electronics parts of the system including
memory sticks must be disposed of according to applicable safety and
environmental regulations.
Customers in member states of the European Union must adhere
to the EU directive 2002/96/EC on waste electrical and electronic
equipment (WEEE). PRÜFTECHNIK products that fall under this
directive are marked with the shown crossed-out wheelie bin symbol
and must be disposed of according to this directive.
 The marked components must be disposed of with
PRÜFTECHNIK or their authorized disposal partners.
 Such parts must be taken to the nearest collection facility.
 If you have any questions regarding the WEEE Directive, please
contact your local PRÜFTECHNIK sales representative.
CAUTION
en