OPERATING AND MAINTENANCE MANUAL
LKS SERIES SUBMERSIBLE ELECTRIC PUMP
Output
lower
4. ELECTRICAL CONNECTIONS
•
The plug of the pump cable must match the socket. Never modify the plug in any way. Do not use any
adapter plugs. Unmodified plugs and matching plugs will reduce the risk of electric shock.
•
Avoid body contact with earthed surfaces.
•
Do not abuse cord. Never use cord for carrying, pulling or unplugging pump. Keep cord away from
heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.
•
When operating a pump outdoors, use an extension cord suitable for outdoor use. Use of a cord sui-
table for outdoor use reduces the risk of electric shock.
•
The pump is equipped with a compatible plug. The power supply in your country must comply with
international regulations.
•
If the power cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid hazards.
WARNING: Improper extension cords can be dangerous. If an extension cord is used, it must be suitable for
outdoor use and the connection must be kept dry and off the ground. It is recommended that this is done
using a cable reel that keeps the plug at least 60 mm above the ground.
5. MAINTENANCE
•
In case of temporary installation, the pump should be cleaned with clean water after use.
•
In case of permanent installation, it is necessary to check every 3 months that the starting mechanism
(float switch or sensor) is working properly.
•
Periodically remove any dirt that may accumulate in the crankcase.
www.proindecsa.com / proindecsa@proindecsa.com
Plastic
plug
Plastic
plug
11
Output
top
ENG