Publicidad
Idiomas disponibles
Idiomas disponibles
ALL-IN-ONE WASHER & DRYER
MAINTENANCE AND CARE
Water Inlet Hoses
Replace inlet hoses after five years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses:
Mark the date of replacement on the label with a permanent
marker.
Check that the old rubber seals on water inlet hoses are not stuck
on the machine inlet valves.
Use new washers in the new inlet hoses to ensure a proper seal.
All-In-One Washer & Dryer Care
Recommendations to Help Keep Your Machine Clean and
Performing at Its Best
1. Always use High Efficiency (HE) detergents and follow the HE
detergent manufacturer's instructions regarding the amount of
HE detergent to use. Never use more than the recommended
amount because that may increase the rate at which
detergent and soil residue accumulate inside your machine
which, in turn, may result in undesirable odor.
2. Use warm or hot water washes sometimes (not exclusively
cold water washes) because they do a better job of controlling
the rate at which soils and detergent accumulate.
3. Always leave the machine door slightly ajar between uses to
help dry out the machine and avoid the buildup of odor-
causing residue.
4. Periodically clean residue from all interior surfaces of the
window. For better care, wipe the entire inside of the door with
a damp cloth.
Cleaning Your All-In-One Washer & Dryer
Read these instructions completely before beginning the routine
cleaning processes recommended below. This machine
maintenance procedure should be performed, at a minimum, once
per month or every 30 cycles, whichever occurs sooner, to control
the rate at which soils and detergent may otherwise accumulate in
your machine. Note that since this is an all-in-one washer & dryer
without a lint screen, you may see some more lint accumulation
on the door seal than a typical washer.
Cleaning the Door Seal
1. Open the machine door and remove any clothing or items
from the machine.
2. Inspect the gray-colored seal between the door opening and
the drum for stained areas, soil buildup, or lint. Pull back the
seal to inspect all areas under the seal and to check for
foreign objects or lint.
3. If stained areas, soil buildup, or lint are found, wipe down
these areas of the seal using either of the following two
procedures:
a. Affresh
®
Machine Cleaning Wipes Procedure:
i. When the cycle is complete, gently pull back the rubber
door seal and clean the entire surface with the textured
side of an affresh
b. Dilute Liquid Chlorine Bleach Procedure:
i. Mix a dilute bleach solution, using 3/4 cup (177 mL) of
liquid chlorine bleach and 1 gallon (3.8 L) of warm tap
water.
ii. Wipe the seal area with the dilute solution, using a
damp cloth.
®
Machine Cleaning Wipe.
iii. Let stand 5 minutes.
iv. Wipe down area thoroughly with a dry cloth and let
machine interior air dry with door open.
IMPORTANT:
� Wear rubber gloves when cleaning with bleach.
� Refer to the bleach manufacturer's instructions for proper use.
Cleaning the Inside of the All-In-One Washer & Dryer
This machine has a special cycle that uses higher water volumes
in combination with affresh
chlorine bleach to thoroughly clean the inside of the machine.
Steam models also utilize steam to enhance cleaning in this
special cycle.
IMPORTANT: Do not use thickened, easy-pour, or no-splash
bleach when running the Clean Washer with affresh
excess suds may occur.
NOTE: Read these instructions completely before beginning the
cleaning process.
Begin procedure
1. Clean Washer with affresh
(Recommended for best performance):
a. Open the machine door and remove any clothing or items.
b. Use an affresh
®
Machine Cleaning Wipe or a soft, damp
cloth or sponge to clean the inside door window.
®
c. Add an affresh
Washer Cleaner tablet to the machine
drum.
d. Do not add the affresh
dispenser drawer.
e. Do not add any detergent or other chemical to the machine
when following this procedure.
f. Close the machine door.
g. Select the Clean Washer with affresh
h. On some models: Select the FanFresh
the machine interior after the cycle is complete.
NOTE: The machine remembers your last option selection
and will use it for future wash cycles until you deselect that
option.
i. Touch and hold START/PAUSE to begin the cycle. The
Clean Washer with affresh
below.
2. Chlorine Bleach Procedure:
a. Open the machine door and remove any clothing or items.
b. Open the single load dispenser drawer and add regular
liquid chlorine bleach to the "MAX" line in both the bleach
compartment and the fabric softener compartment. Either
traditional or HE chlorine bleach can be used.
IMPORTANT: Do not use thickened, easy-pour, or no-
splash bleach as excess suds may occur.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause machine damage over
time.
c. Close the machine door and the dispenser drawer.
d. Do not add any detergent or other chemicals to the
machine when following this procedure.
e. Select the Clean Washer with affresh
f. On some models: Select the FanFresh
the machine interior after the cycle is complete.
NOTE: The machine remembers your last option selection
and will use it for future wash cycles until you deselect that
option.
®
Washer Cleaner or regular liquid
®
®
Cycle Procedure
®
Washer Cleaner tablet to the
®
cycle.
®
option to help dry
®
cycle operation is described
®
cycle.
®
option to help dry
cycle as
5
Publicidad
