Bellman & Symfon BE1411 Manual De Usuario página 94

Alternative installation – single sound source
Using the external microphone accessory
1 Connect the external microphone (sold separately) to the transmitter. Remove
the protective film and attach it to the doorbell's sound source.
2 Pull the battery tab to start the transmitter. Remove the protective film from the
Velcro and mount the transmitter on the wall.
3 Within 2 min, press the lower button 10 times to turn off the internal micro-
phone. The LEDs will blink 3 times in red to confirm.
Note: If you exceed 2 minutes, you need to restart the transmitter by removing
the batteries and putting them back in again.
1
186
2 3
x10
Installation – hardwiring your doorbell
1 Pull the battery tab to start the transmitter. Within 2 min, press the lower button
10 times to turn off the internal mic. The LEDs will blink 3 times to confirm.
2 Remove the front cover to access the screw terminal. There are 3 connection points:
Use 1 and 2 to connect an active

rent (2–30VDC, polarity independent or 2–24VAC, 5 - 150Hz).
Use 2 and 3 to connect a passive

3 Put the front cover back, remove the protective film from
the Velcro and mount the door transmitter on the wall.
1
x10
Ext. trig
switch, like a relay with cur-
switch, like a push button.
2 3
Ext. trig
App
187