Use Instructions (For The User); Residual Risks (For The User) - Royal Catering RC-523M Manual De Instrucciones

________________________________________________________________ use and instruction manual _
Steam outlet
The appliance is equipped with a special metal tube (DN30), to exhaust the steam from the
cooking chamber.
No other type of pipe can be connected to this pipe, which protrudes from the back of the
enclosure.
Failure to comply with this specific prohibition will allow the Manufacturer to reject any
responsibility coming from the possible malfunction of the appliance and the poor quality of
the cooking operations.
Increasing the length of the original exhaust pipe may cause abnormal condensation inside
the cooking chamber.
To prevent steam from escaping from the exhaust pipe, place the appliance under the
extraction hood.
Connection of power cable - The terminal board is on the rear panel of the appliance. Open
the terminal board cover by obtaining leverage with a screwdriver on the two side fins.
Loosen the cable gripper screw and allow the cable to pass through it. Arrange the
conductors so that the earth conductor is the last to detach from its terminal if the cable
goes into a state of faulty traction. Connect the phase conductor to the terminal marked
with the letter "L", the neutral conductor to the terminal marked with the letter "N" and
the earth conductor to the terminal marked with the symbol
cable gripper and close the terminal board cover. The appliance must be connected to an
equipotential system whose efficiency must first be checked according to current legal
regulations. This connection must be made between different appliances by using the
appropriate terminal marked with the symbol
minimum diameter of 2,5 mm
Safety thermal breaker - The appliance has a manually reset safety thermal breaker. It
protects against excessive dangerous over-temperatures which could be accidentally
generated inside the appliance. If the device is tripped, it interrupts electrical power to the
appliance and thus prevents it from operating.

5. Use instructions (for the user)

This appliance is not intended for use by persons (including children) with reduced phycal,
sensory or mental capabilities, or lack of experience and knowledge. Unless they have
beengiven supervision or instruction concerning use of appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance
For first use, we advise you to let the appliance to run load-free at maximum temperature
for about one hour. In this way, any unpleasant smells due to thermal insulation and residual
work grease are eliminated.
This appliance must be used solely for the purpose for which it was expressly designed, i.e.
cooking foods in the oven. Any other use is considered unsuitable.
The appliance can be used: for all oven cooking of deserts, pizzas, meat, fish, vegetables, as
well as for gratinating, and for re-conditioning cooled and frozen foods.
When placing food in the cooking compartment, leave a space of at least 40 mm between
pans in order not to over-obstruct air circulation.
Do not use pans with higher than necessary edges: edges are barriers which prevent the
circulation of hot air.
Warm up the oven before every cooking operation to obtain maximum uniformity.
Do not salt foods in the cooking compartment.

6. Residual risks (for the user)

After a cooking operation, open the door cautiously, to avoid a violent outflow of heat
which could cause burns.
_ page 6 _____________________________________________________________________________________
. The equipotential conductor must have a
2
The equipotential terminal is at the rear of the appliance.
. Tighten the ring-nut of the