Descargar Imprimir esta página

HOMCOM 820-258V90 Manual De Montaje E Instrucciones página 5

Publicidad

Idiomas disponibles

Idiomas disponibles

OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat, e.g. due to the total or partial obstruction of the
grids. In this case, unplug the appliance, wait about 30 minutes for it to cool and
remove the object which is obstructing the grids. Then switch it back on as
described above. The appliance should operate normally. Should the problem
persist, please contact the nearest customer service.
TIP-OVER PROTECTION
This heater is protected with a safety switch that turns off the appliance
automatically when the heater falls over, or is at an excessive angle from the
horizontal. This helps prevent accidents, and the heater will back to the standby
mode when it is put back upright, press the buttons on control panel or remote
control to reset the heater
MAINTENANCE
1. When your heater needs cleaning, wipe exterior surfaces of the heater with a
moistened cloth. Not rinse with water directly. Be sure to unplug before cleaning.
2. Pull out filters and clean them , when it's very dirty.
3. To prolong the heater life, not disassemble it personally when malfunction
occurs. Send your heater to relative identification after-sold service center or
provider for the convenience inspecting.
CORRECT DISPOSAL OF THIS PRODUCT
When the time comes to eliminate this product, please consider the
environmental impact and take it to recognized recycling facility instead
of disposing it with general household waste. Take the equipment to a
waste disposal site. Plastic and metal parts that are used in the
construction of this appliance can be separated into pure grade which
allow recycling. Ask to your service center for details. Everyone of us
can participate on the environmental protection.
SPECIFICATIONS
Power supply:
220-240V~50Hz
Power range:
2000W
4
EN

Publicidad

loading