Descargar Imprimir esta página

hillvert HT-ES-1500 Manual De Instrucciones página 34

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 104
To reduce the risk of damage to the lawn during start-up, press the handle (1)
slightly down to lift the front of the appliance before starting it. After starting the
appliance, return to the required position.
Operating the appliance
Do not operate the appliance with one hand - it must be run with both hands. Do
not use the appliance on sand, concrete or wooden substrates.
During scarification/aeration activities, the connection cable should be laid safely in
the already operated area.
Handle the appliance as shown below (in the drawing with the acceptance mark)
from position 1 to position 2, and after reaching position 2, turn right and move to
position 3. Continue to the end of the cutting area, turn left and move to position 4.
Continue in the same way as shown in the figure, always moving away from the
cable. Do not use the method shown below in the adjacent drawing (with a cross),
i.e. going towards the cable, because it is a dangerous practice.
Operating depth settings:
The appliance operating depth can be set according to the table below.
Setting
1
2
3
4
5
The roller with spring-loaded claws can only be used for settings 1, 2 and 3. A deeper
setting does not enhance performance, but can even result in spring snapping.
Springs are designed in such a way that it is not necessary to go deeper into the soil.
Depth [mm]
+10
-3
-6
-9
-12
Roller with
Roller with spring-
cutters
X
V
V
V
V
loaded claws
V
V
V
X
X

Publicidad

loading