EN
ELBA LCD DIGITAL TOWEL RAIL
!
IMPORTANT
Disconnect the product from the power supply and make
sure the product is at room temperature before any cleaning
or maintenance. Do not use any abrasive substances on
the product, such as (but not limited to) chemicals, coarse
cloths, brushes, hard bristle, or wire/steel wool.
To disconnect the product from the power source, remove
the mains plug from the socket. Do not pull on the cable.
ROINTE cannot be held responsible for incorrect sizing of
the product unless it has been followed by an official ROINTE
technical study.
Before the first start-up, or before the start of winter, or when
the product has not been used for many days, the appliance
should be cleaned (follow the steps in the "maintenance"
section of this manual).
Do not sit or lean on the product.
Temperature contrasts can generate "clicks" or noises in
the device. This is not a fault of the product, but due to the
expansion/contraction of the materials.
When disposing of the product, the requirements set out in
the legislation for the waste treatment and recycling must be
followed. See WEEE in section 7.
7