Publicidad
Idiomas disponibles
Idiomas disponibles
Do not install a smoke sensor in the following places:
Areas where combustion occurs under
normal conditions such as kitchen, fire-
place or areas where appliances such as
kettle are located. Use special sensors
for these areas that control unwanted
alarms.
High-humidity areas such as bathrooms
or areas where dishwashers and washing
machines are located. Install the sensors at
least 3 meters away from these areas.
Battery
Voltage :
Package :
Battery Specifications:
1.
Turn the sensor body counterclock-
wise and separate it from the mounting
bracket.
2.
Remove the old batteries from the bat-
tery compartment.
3.
Insert two new batteries into the battery
compartment. Pay attention to the pos-
itive and negative terminals of the bat-
tery while placing it.
4.
Place the sensor body on the support by
turning it clockwise.
DC 1.5V
AA Alkaline Battery
Areas with ventilation or where heat-
ing/cooling drains are located. Install at
least 3 meters away from these areas,
airflow can keep smoke away from the
alarm, preventing it from sounding.
Areas where the temperature may drop
below 0° or rise above 40°.
Extremely dusty, dirty, insect-infested ar-
eas. Particles in these areas can disrupt
the functioning of the sensor.
5.
Test the sensor using the test button. The
sound pattern that should be produced
is 3 short beeps followed by a 1.5 sec-
ond pause. This pattern repeats. If there
is no sound, it means that the sensor is
malfunctioning or there has been an er-
ror during the installation. You can take
a look at the troubleshooting section for
any steps to be taken to solve problems.
5
Publicidad
