Publicidad
Idiomas disponibles
Idiomas disponibles
1006292-00 11651 grinderREV
Minimum Gage for Cord Sets
Volts
Total Length of Cord in Feet
120V
0-25
26-50
240V
0-50
51-100
Ampere Rating
More Not more
AWG
Than Than
0 -
6
18
16
6 -
10
18
16
10-
12
16
16
12-
16
14
12
MOTOR
Be sure your power supply agrees with
nameplate marking. 120 Volts AC only
means your tool will operate on standard
60 Hz household power. Do not operate
AC tools on DC. A rating of 120 volts
AC/DC means that your tool will operate
on standard 60 Hz AC or DC power. This
information is printed on the nameplate.
Lower voltage will cause loss of power
and can result in over-heating. All Craftsman
tools are factory-tested; if this tool does
not operate, check the power supply.
OPERATION
AUXILIARY HANDLE (FIG. 1)
A three position auxiliary handle (5) is
furnished with your grinder and can be
screwed into either side of the grinder
housing as well as into the top. This
handle SHOULD BE USED AT ALL
TIMES to maintain complete control of the
tool. Always make sure handle is tight.
STARTING THE TOOL
To switch your angle grinder on, depress
the trigger switch (1). The angle grinder
will stop when the trigger switch is
released. For continuous operation
depress the lock-on button (2) while the
trigger switch is depressed. Release the
trigger switch prior to releasing the lock-on
button. To stop your angle grinder when
operation is continuous depress the
trigger switch again and release.
OVERLOAD
Overloading will cause damage to the
motor of your angle grinder. This can
happen if your angle grinder is subjected
to heavy use for prolonged periods of
time. Do not in any circumstances,
attempt to exert too much pressure on
your angle grinder to speed up your work.
The abrasive discs operate more
efficiently when light pressure is exerted,
thus avoiding a drop in the speed of your
angle grinder.
4/16/07
10:53 AM
51-100
101-150
101-200
201-300
ATTACHING THE WHEEL GUARD
16
14
(FIG. 2)
14
12
14
12
TURN OFF AND UNPLUG THE TOOL.
Not Recommended
NEVER GRIND OR BRUSH WITHOUT
GUARD (6) IN PLACE.
1. Place the tool on a table, with the
spindle (9) facing up.
2. Place the spring washer (8) over the
spindle and locate it on the shoulder
(10).
3. Place the guard (6) onto the tool as
shown.
4. Place the flange (7) over the spindle
with the protruding tips towards the
guard. Make sure that the holes in the
flange align with the screw holes.
5. Secure the flange with the screws
(11). Make sure that the screws are
fully tight and that the guard can be
rotated.
2
GRINDING WITH DEPRESSED-CENTER
WHEELS (FIGS. 3,4,5,6)
TURN OFF AND UNPLUG THE TOOL.
CAUTION: Never use depressed-
center wheels without the proper guard.
TO INSTALL DEPRESSED-CENTER
WHEELS
1. Ensure that the guard is fitted
properly. Place the inner flange (A) in
Fig. 3 on the spindle. Ensure that it is
located on the two flats.
2. Place the grinding disc on the
inner flange (A) in Fig 3.
5
Page 5
GRINDING AND WIRE
BRUSHING
11
11
7
6
9
8
1 0
Publicidad
