Continuous operation:
In continuous operation, the unit works continuously until the water tank is full or the
dehumidifier is switched off manually.
In this mode, the unit operates at maximum air output to dehumidify the room air as quickly
as possible.
During operation, the current humidity is shown on the display.
Tip: This mode is very suitable for drying laundry.
Timer:
Press the timer key to start the timer function. Then use the two arrow keys to set the desired
run/start time from 1-24 hours. If the timer is activated, this is indicated by the corresponding
LED.
If you activate the timer during operation, the appliance switches off after the set time.
If you activate the timer while the unit is in standby mode, the unit will start automatically
after the set time has elapsed.
To switch off the timer, press the key again and set the running time to "00" using the two
arrow keys.
If the unit is switched off via the on/off switch, the timer function is also deactivated.
Speed:
The fan speed can only be changed in automatic mode.
Press this button to switch between the two fan speeds.
The currently selected fan speed is displayed via the two LEDs.
Press Mode and then this arrow key to reduce the target humidity in 5% steps.
Press the timer and then this arrow key to reduce the start/run time in 1 hour steps.
Press Mode and then this arrow key to increase the target humidity in 5% steps.
Press the timer and then this arrow key to increase the start/run time in 1 hour steps.
Child lock
Press and hold this key for at least 3 seconds to switch the child lock/key lock on or off. If the
child lock is activated, the corresponding LED lights up.
Sleep/Reset
Press this button to switch the sleep function on or off.
In "Sleep" mode, the unit operates at a low fan speed with a fixed target humidity of 60%.
When the mode is active, the indicators for the sleep function, the child lock and power are
dimmed. All other displays go out.
Activate the timer before you start the sleep function and the dehumidifier will switch off after
the set runtime.
ENG-10