Main Brush - Redroad G10 Manual De Instrucciones

Product Maintenance
3. Take out the filter as shown in the figure, clean the dust
compartment and filter with a dust brush, clean it with clear water,
dry it and put it back in.
Note: It is recommended to thoroughly clean the dust compartment at least
once a week. Please dry the dust compartment and filter before use.
Dirty water tank/Dirty water filter
Take out the dirty water tank and dump the sewage; lift up the
cleaning brush and take out the sewage mesh for cleaning.
Notes:
• After mopping the floor, please take out and clean the dirty water tank in
time, and clean the cleaning brush, cleaning tray and dirty water filter to avoid
odor and mildew.
• Clean the dirty water filter regularly to prevent hair and dirt from blocking the
drainage hole.
Cleaning brush
Cleaning tray
Dirty water filter
(Alignment with the slot
with magnetic installation)
13

Main Brush

1. Turn over the vacuum-mop and press the two release buttons to
remove the main brush cover.
2. Take out the main brush upward.
3. Pull out the main brush axle sleeve outward.
4. Rotate the main brush bracket so that the alignment identification on
the main brush bracket is aligned with the unlocking identification and
remove the main brush brackets at both ends of the main brush.
5. Cut the hair wound on the main brush with a knife on the dust brush
and clean the main brush.
6. Install main brush bracket and main brush axle sleeve back.
7. Replace the main brush and main brush cover, and press the main
brush cover to install it in place.
Locking identification
Alignment
identification
Unlocking identification
Main brush cover
Locking
Release
identification
button
Main Brush
Main brush
axle sleeve
Alignment
Main brush
identification
bracket
Unlocking
identification