Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 6: Attach the Log Cradle
1. Attach log cradle (#53) to the beam using hex bolt M10x35 (#129) and hex lock nut M10 (#114). The
tightness is appropriate for log cradle rotation.
STEP 7: Add Engine Oil
1.
Make sure the log splitter is on a level surface.
2.
Remove oil fill cap/dipstick to add oil.
3.
Refer to the separate owner's engine manual for the amount needed of SAE10W-30 engine
oil; replace oil fill cap/dipstick.
4.
Check engine oil level daily and add as needed.
NOTE: During the break-in period check the engine oil level often.
DO NOT attempt to crank or start the engine before it has been properly filled with the recommended
type and amount of oil. Damage to the log splitter as a result of failure to follow these instructions will
void your warranty.
STEP 8: Add Gasoline to the Engine
1.
Use only clean, fresh, regular unleaded fuel with a minimum 86 octane rating.
2.
DO NOT mix oil with fuel.
3.
Remove the fuel cap and slowly add fuel to the tank. DO NOT overfill allow approximately ¼
inch of space for fuel expansion.
4.
Screw on the fuel cap and wipe away any spilled fuel.
CAUTION
Publicidad
