Fein ASzxeu 636-1 Kinetik Instrucciones De Manejo página 10

ASzxeu 636-1 - Buch Seite 10 Dienstag, 26. September 2000 5:40 17
EN
Operating the power tool.
Switching ON/OFF (2).
First check that the cable and plug are
not damaged.
Switching the power tool ON:
Press switch (2). Speed according to
how far the switch is pressed in.
Switching the power tool OFF:
To turn off, release switch.
Locking for continuous mode:
When the switch (a) is fully pressed in
(= maximum speed) press the locking
button (b).
To release, press switch (a) again and
then let go.
Select direction of rotation (3).
Set the direction of rotation using
selector switch for clockwise and anti-
clockwise rotation.
Only operate when power tool is at a stand-
still.
Drilling.
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Clamp the drill bit in the drill chuck (1)
using the drill chuck spanner.
Switch the power tool ON and OFF
using switch (a).
10
ASzxeu 636-1 Kinetik
Screwing.
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Twisting the wrist when driving the screw
head. Only drive the screws into soft material
(e. g. wood, plastic dowels) at low speeds.
Caution! Danger of skidding off when driving
in long screws!
Clamp the tool in the drill chuck (1)
using drill chuck spanner.
Set the power tool onto the screw
head.
Switch the power tool ON and OFF
using switch (a).
Always work at low speeds.
Changing the drill chuck (4).
!
Risk of injury
by switching the tool ON unintentionally.
Before changing the tool, pull out the mains
plug.
Before mounting the drill chuck,
remove any grease from the drilling
shaft.
Mount the drill chuck onto the drilling
shaft and attach by knocking lightly
with a hammer.
To remove the drill chuck, open the
clamping jaws and press the drill chuck
off the drilling shaft over the inner
M 8 press-off thread using a screw.