Important Warnings - UFESA AS5250 Manual De Instrucciones

IMPORTANT WARNINGS

Prior to plugging in the product, check that your mains voltage is the same as the one indicated on
the product label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not pull on the connection cord in order to unplug it.
Do not use, connect or disconnect the device to the mains with your hands or feet wet.
Proceed according to the conservation and cleaning section of this manual for cleaning.
Unplug the product immediately from the mains in the event of any breakdown or damage and con-
tact an authorised Technical support service.
In order to prevent any risk of danger, do not open the device. Only qualified technical personnel from
the brand´s Official Technical support service may carry out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty null and void. Only an
authorised technical support service centre may carry out repairs on this product.
This appliance is designed exclusively for domestic use, in no case should be a commercial or indus-
trial use. In case of misuse or tampering with the product, it will be out of warranty.
Do not use the appliance to vacuum liquids (water, etc), sharp objects (pins, pins, nails, glass, etc), in-
candescent objects (matches, cigarettes)
Never use the turbobrush to: Polish floors, suck (Liquids, wet or damp dust, hot ash, burning objects,
such as cigarettes, matches, sharp and hard items, such us: razors, pins, thumbtacks, pieces of glass,
etc), flour, cement, plaster, printer or photocopier toner, etc.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.
INSTRUCTIONS FOR USE
ASSEMBLING THE VACUUM CLEANER
Removing the flexible tube
Remove the plug fromthe pover socket. Torefease the flexible
Tube, press the button on the end of the tube and pull the tube firmly from the air intake duct.
INSTRUCTIONS FOR USE
1,Before using the appliance.unwind length of cable and insert the plug into the power socket. Do not
extend the cable beyond the RED mark. To rewind the power cable, press the rewind button(1)with one
hand,and guide theother hand to ensure that it does not whip causing damage
2.Press the ON/OFF button(2)to switch the appliance on .it is advisable to set set the electronic power
regulator to MIN before switching the applice on.
3.By turning the speed control knob the absorption power can be adjusted.
12