EAS ELECTRIC ECRL120P Manual De Instrucciones página 38

3. INSTALLATION METHOD
3.Wiring figure
Connect the female joint of wires group from the mainboard with
the male joint of connective wires group. (See Fig.3-3)
Please connect the other side of connective wires group with the
male joint of wires group leads from wire controller. (S ee Fig.3-3)
4.Remove the upper part of wire controller
Insert a slot screwdriver into the slots in
the lower part of the wire controller (2
places), and remove the upper part of
the wire controller. (Fig.3-4)
NOTICE
The PCB is mounted in the upper part
of the wire controller. Be careful not to
damage the
screwdriver.
4-core shielding wire
board with the
Connective wires group-1
Connective wires group-2
slot
Slots
39
Mainboard
CN40
Fig 3-3
Fig 3-4
V.2