EAS ELECTRIC ECRL120P Manual De Instrucciones página 41

3. INSTALLATION METHOD
7. Wiring
Top side
wire outlet
Line groove
Left side
wire outlet
Line groove
Bottom side
Line groove
wire outlet
Embedded switch
box wiring
Wiring
hole
Avoid the water enter into the wired remote controller, use trap and putty to seal
the connectors of wires during wiring installation. (Fig.3-10)
When under installation, reserve certain length of the connecting wire for
convenient to take down the wired remote controller while during maintenance.
Right side
wire outlet
Line groove
Fig 3-8
B.Shielded wiring
Wiring through the wall
Wall hole and wiring hole
Diameter of wall hole：
Fig 3-9 Φ20mm
A. For wiring in the slot, four outletting positions.
There are three need cutting.
Cutting place of top
side wire outlet
Putty
CAUTION
42
Cutting place of right
Cutting place of left
side wire outlet
side wire outlet
Trap
Putty
Fig 3-10
Putty
Trap
Trap
V.2