Publicidad
Fuel Filling Up
Motor Fuel Supply
• Follow the safety standards for handling fuel (page 5).
• Allow the motor to cool down completely before
supplying fuel.
• Set the Gas Brushcutter into a flat surface.
• Wipe clean around the fuel tank cap to prevent
contamination.
• Slowly loosen the fuel tank cap.
• Use care to prevent leakages. Pour the fuel mix into the
CAUTION
tank.
Follow the fuel specifications
(page 3).
• Before putting the cap back into the fuel tank check and
wipe clean the joints.
• Set immediately the fuel tank cap ant tighten with your
hand.
• Wipe clean any fuel spills.
Start Up
Starting the Motor When Cold
• Set the Gas Brushcutter on levelled ground using care
the blade is not making contact with any obstacle.
• Set the switch into the ON position (A).
• Press and release the Primer bulb 10 times (B).
• Move the Starter choke lever upwards (C).
• Press simultaneously the trigger release and the throttle
trigger. Still holding the trigger, push in the throttle lock
button and release the trigger.
• Pull the jack-line (D) to start the motor. DO NOT pull
more than 4 times to prevent flooding the motor.
• If the motor does not start, move the Starter choke lever
downwards (E). Pull again the jack-line (F) until the motor
starts. DO NOT pull more than 6 times (although, in cold
weather the jack-line has to be pulled more time).
• If the motor is still not starting, repeat steps from B and
on.
• Once the motor starts, leave it running a couple of
seconds in that position.
• Press and release the throttle trigger to run the motor
idle (G).
• The Gas Brushcutter is ready to operate. Hold both handles
and lift it to start the job.
CAUTION
With new motors, it is normal to observe
smoke emissions during and after is used for the first
time.
A
C
E
B
x10
x4
D
x6
F
G
ENGLISH
9
Publicidad
