Descargar Imprimir esta página

WERKU WK400890 Instrucciones Originales página 2

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
ENG
CE DECLARATION CONFORMITY.
Werku
declares that the WK400890 pressure-
®
washer is in accordance with the European
Directives and Standards 2006/42/CE,
EN60335-1:2012/A11:2014
EN60335-2-79:2012
EN62233:2008
La Coruña, 01/07/2019
R Yáñez
Werku Tools SA
TECHNICAL CHARACTERISTICS.
Voltage-frequency 230V~50Hz
Class I
Protection index IPX5
Working pressure 70 bar
rate 2800 min
-1
Maximum pressure 100 bar
l/min
Maximum flow 6.5 l/min
-1
temperature 50º C
pressure LpA <75 dB(A)
<86 dB(A)
Vibration Aw <2.0 m/s².
PICTOGRAMS.
Attention
Risk of electric shock
Do not connect directly to water mains
Risk of high pressure jet
Read instruction manual
Use eye protection
Use hand protection
Use body protection
European conformity
Power 1300W
Speed
Working flow 6
Maximum
-1
Net weight 10 kg
Acoustic
Acoustic pressure LwA
Double insulation
Waste electrical and electronic equipment
SAFETY INSTRUCTIONS.
Read all security warnings and all instructions
Failure to follow all warnings and instructions
listed below may result in electrical shock, fire
and/or serious injury
all instructions for future reference
can be avoided in many cases by recognizing a
potentially hazardous situation before it occurs and
by observing appropriate safety procedures
not use this pressure-washer for other applications
than those specified in this manual.
ELECTRIC COMPONENTS.
Danger; risk of electric shock
mains plug and the socket with wet hands
the power cord with mains plug for damage prior
to every use
cord replaced by an authorised customer service
/ electrician
power cord is damaged
parts in the working area must be protected against
jet water
The mains plug and the coupling of an
extension cable must be watertight and must never
lie in water
lie on the ground
ensure that the sockets are at least 60 mm above
the ground is recommended
power cord or extension cable is not damaged by
running over, pinching, dragging or the like
the power cords from heat, oil, and sharp edges
Turn off the appliance and remove the mains plug
prior to any care and maintenance works
work and work on the electrical components may
only be performed by an authorised customer
service
Warning; the appliance may only be
connected to an electric supply that has been
installed by an electrician in accordance with IEC
60364
The appliance may only be connected to
alternating current
with the type plate of the appliance
I
Appliances may only be connected to sockets
with proper earthing
recommend that you operate the appliance only via
a residual current device (max. 30 mA)
electrical extension cable can be hazardous
use an electrical extension cable which has been
approved and labelled for this purpose and has an
adequate cable crosssection outdoors: 1 - 10 m: 1.5
mm
; 10 - 30 m: 2.5 mm
2
extension cable from the cable drum.
2
English
Keep all warnings and
Never touch the
Immediately have damaged power
Do not operate an appliance if the
All current-conducting
Moreover, the coupling may never
The use of cable reels that
Make sure that the
The voltage must correspond
For safety reasons, we
Always fully unreel the
2
Accidents
Do
Check
Protect
Repair
Safety class
Unsuitable
Only

Publicidad

loading