Height Adjustable Dual Post Flip Back Armrest - Ki Mobility Focus CR Manual De Instrucciones Y Garantía

IV. WHEELCHAIR USE & CONFIGURATION
I. Height Adjustable Dual Post Flip Back Armrest
WARNING: These arms offer only a lock against rotation and are designed to bear a
downward force only. They will remove completely if pulled up on and cannot be used to
lift or otherwise handle the chair. Failure to comply with the instructions above may result
in the armrest accidentally disconnecting from the wheelchair and result in a fall or loss of
control and may cause serious injury or death.
How to Use Your Armrest
1. Installation
a. Flip both of the levers (Fig. 5:A & B) upward.
b. Set both of the armrest posts into the receivers until they are seated against the bottoms
of the receivers.
c. Flip the levers back downward. Ensure the locking pins are seated by lightly pulling the
armrest up.
2. Height Adjustment
a. Flip the lever (Fig. 5:C) forward.
b. Adjust the height of the armrest by pushing down or pulling up on the arm pad near the
center of the armrest pad.
c. When the desired height is achieved, flip the lever rearward again and move the armrest
slightly up or down to allow the pin to seat in the nearest hole.
3. Flipping Back the Armrest
a. Flip the lever (Fig. 5:A) on the front armrest receiver.
b. Lift upwards on the arm pad and the cross tube, allowing the armrest to flip back.
4. Removal
a. Flip the levers (Fig. 5:A & B) on both of the receivers upward.
b. Lift the armrest out of the receivers by pulling up on the arm pad and the cross tube.
Fig. 5
C
A
B
22